[. . . ] If the cable is damaged, replace it immediately as follows: - open the terminal board cover, remove the power cable and replace it with one of a relative length with rubber insulation (H05RR-F) and sufficiently large for the rated power of the appliance. The earth wire (yellow - green) must be about 10 mm longer than the line wires. In case the appliance needs repairing, contact an authorised technical service centre and make sure original spare parts are used. [. . . ] Five seconds after releasing the function key or finishing the setting, the display returns to the clock. Setting the time (clock) Select the clock function by simultaneously pressing the Duration and End of cooking time keys and adjust the clock by means of the +/- keys. Semi-automatic operation and cooking duration Press the Cooking duration key and set the duration by means of the +/- keys. Semi-automatic operation and end of cooking time Press the end of cooking time key and set the required time by means of the +/- keys. Completely automatic operation Press the duration key and set the required time by means of the +/- keys. Minute control Press the Minute control key and set the required time by means of the +/- keys. program start-up and check A set program is run when the required time has also been set. The remaining timers can be checked at any time by selecting the relevant function. Setting error The setting is not correct if the clock time is between the beginning of cooking time and the end of cooking time. the error is indicated via sounding of a buzzer and blinking of the Auto symbol. An incorrect setting can be corrected by re-setting either the beginning or end of cooking time. cancelling a program A program can be cancelled by selecting the manual function. A set program is automatically cancelled when it reaches the end of its cycle. The glass panel can be easily removed and cleaned by unscrewing the four screws at the side (fig. [. . . ] The appliance is provided with a guarantee certificate which entitles the user to free use of the TECHNICAL SUPPORT SERVICE for one year from the date of purchase, the only expense being a fixed call-out fee. The guarantee certificate must be filled in and kept so that it can be shown to the TECHNICAL SUPPORT SERVICE. 6) The oven can be housed below the worktop or in a column unit by means of 4 screws. [. . . ]